Balance pak 300
Bioguard
Balance your water to prevent problems
Keeping the right balance of your swimming pool water is necessary. Balancers control scale, prevent metallic stains, adjust pH and total alkalinity and correct mineral imbalances.
Balance Pak 300:
Used to raise calcium hardness in swimming pool water. Surface life (painted, vinyl and fibreglass) can be shortened if calcium hardness remains low. Plaster etched by low calcium hardness will become abrasive and uncomfortable for swimmers. Rough plaster makes cleaning difficult and increases algae problems. Calcium hardness in plaster and fully tiled pools should be maintained in the 200-275 ppm range. Calcium hardness in pools with vinyl and fibreglass surfaces should be maintained between 175-225 ppm. Never allow hardness to remain below 100 ppm.
- For raising calcium hardness levels
- Protects pool equipment from corrosion, plaster etching and wrinkling of liners
Instructions:
- Perform an analysis of your swimming pool water.
- Add directly to the deep end of the pool the amount needed according to your analysis.
- Make sure the pump is running and water is circulating.
- Brush the undissolved residue from the surface of the pool.
ADVICE: If a large amount is needed, divide the dose into 3 parts. Add a third of this total dose every 6 hours so as not to cloud the water.
NOTE: To increase the calcium hardness level by 10 ppm, please add 100 g of Balance Pak 300 per 10,000 L of water.
