Balance pak 100

Bioguard

Balance your water to prevent problems

Keeping the right balance of your swimming pool water is necessary. Balancers control scale, prevent metallic stains, adjust pH and total alkalinity and correct mineral imbalances.


Balance Pak 100:

Used to raise total alkalinity in spa water. Low alkalinity causes spa water to be corrosive and irritating and may result in stainning and etching of the spa surface. Low total alkalinity may cause pH to fluctuate excessively when being adjusted. This is known as pH bounce. For these reasons, total alkalinity in the pool water should be maintained in a proper range.

• For raising total alkalinity.
• Prevents pH change.
• Prevents corrosion and vinyl liner wrinkling due to improper pH.

Instructions:

1. Perform an analysis of your swimming pool water.
2. Add directly to the deep end of the pool the amount needed according to your analysis.
3. Make sure the pump is running and water is circulating.
4. Brush the undissolved residue from the surface of the pool.

NOTE: Adding 180 g of Balance Pak 100 will increase the total alkalinity by 10 ppm per 1000 L of pool water.